Comtech EF Data CDM-570A Installation And Operation Manual page 290

CDM-570A/570AL Satellite Modem with Optional Packet Processor
Serial-based Remote Product Management
Command
Parameter (Instruction
Type Code and
Qualifier)
Faults and
Status (continued)
Arguments for
Command or
Response to
Query
b = Tx Traffic status:
0 = Tx traffic OK
1 = No clock from terrestrial interface
2 = Tx PaP ETH Link Down
3 = Tx FIFO slip
4 = G.703 Loss of Signal (valid only in Clock Extend Mode)
5 = Loss of External Reference
6 = Reserved
7 = AUPC upper limit reached
8 = Reserved
9 = AIS detected on incoming data
A = Reserved
B = Bipolar violation on G.703 interface
C = Reserved
D = Reserved
E = Reserved
F = BUC Alarm (if attached)
c = Rx Traffic status:
0 = Rx Traffic OK
1 = Demodulator unlocked
2 = Reserved
3 = AGC Alarm - signal out of range
4 = Reserved
5 = RS Frame sync alarm
6 = Reserved
7 = EDMAC Frame sync alarm
8 = APC Band mismatch alarm
A = Buffer Underflow
B = Buffer Overflow
D = Eb/No alarm
E = LNB Alarm (if attached)
F = AIS detected on incoming data
9 = Reserved
A = Buffer Underflow
B = Buffer Overflow
C = Reserved
D = Eb/No alarm
E = LNB Alarm (if attached)
F = AIS detected on incoming data
Description of Arguments
8–46
MN-CDM570A
Revision 3
Query
Response to Response to
(Instruction Code
Command
and Qualifier)
Query