Odu | Config (Kst-2000A/B) - Comtech EF Data CDM-570A Installation And Operation Manual

CDM-570A/570AL Satellite Modem with Optional Packet Processor
CDM-570A/570AL ODU (Transceiver, BUC, LNB) Operation
10.2.2.1.2.2

ODU | Config (KST-2000A/B)

Figure 10-8 shows the 'ODU | Config' page with the KST-2000A/B configured as the ODU. Use
this page to configure the primary KST-2000A/B Transmit and Receive Parameters.
Upconverter Parameters
• Frequency – Enter a value in MHz.
•
Attenuation – Enter a value in dB.
• Output – Select On or Off from the drop-down list.
Downconverter Parameters
•
Frequency – Enter a value in MHz.
•
Attenuation – Enter a value in dB.
• Rx Band (For KST-2000B Only): Select band A (10950 to 11700 MHz), band B (11700 to
12200 MHz), or band C (12250 to 12750 MHz) from the drop-down list
HPA Parameters
• HPA Power Enable – Select On or Off from the drop-down list.
•
HPA Fault Logic – Select Summary or No Summary from the drop-down list.
LNA Parameters
• LNA Power Enable – Select On or Off from the drop-down list.
•
LNA Fault Logic – Select Summary or No Summary from the drop-down list.
Figure 10-8. ODU | Config page (KST-2000A/B)
10–29
MN-CDM570A
Revision 3