Comtech EF Data CDM-570A Installation And Operation Manual page 330

70/140 mhz satellite modem; l-band satellite modem; reduced chassis depth l-band satellite modem
Hide thumbs Also See for CDM-570A:
Table of Contents

Advertisement

CDM-570A/570AL Satellite Modem with Optional Packet Processor
Optional Packet Processor - Serial/Telnet CLI Operation
Selection
Route001 through
Route256 (continued)
Base [#]
Delete Route
Display
PerRoute
Downlink Mcast
Hot Key Description
Route Multicast packets from Ethernet to Satellite? [y/n]
o
Specifies if Multicast packets that match the provided IP address
are routed from the Ethernet to Satellite. "No" means that the
packets are discarded.
Route Multicast packets from Satellite to Ethernet? [y/n]
o
Specifies if Multicast packets that match the provided IP address
are routed from the Satellite to Ethernet. "No" means that the
packets are discarded.
Multicast Routes always have a subnet length of 32 and the next
hop is 0.0.0.0 because it is not applicable.
Note: The Packet Processor does allow the specification of one and only
one default route. Destination IP = 0.0.0.0 Subnet Length = 0. The default
route can be defined to send traffic to either the Satellite or Ethernet
interface. This will cause all packets that do not match any other route to be
sent to the destination that has been defined for further processing.
B
Set a value, from 1 to 249, to display or edit the group of eight of up to 256
definable QoS Routes.
For example, if you want to edit Routes 32-40: Type 'B', and then type '32'
to select the Base value of 32. The QoS Configuration page will refresh to
display Route032 through Route040.
D
Set the number of the Route Name (1 through 8) you want to delete.
P
Displays all of the routes that are currently defined in the system. This
includes automatically generated routes that are provided to simplify
provisioning of the system. The information displayed is: Route Name,
DestIP/Snet Bits, Next Hop, HDLC, and Flags.
E
Use to enable Header Compression, Payload Compression on a Per Route
basis.
[RO]
Displays the status of Downlink Multicast as [Enabled] or [Disabled]. This
feature is configured on the Administrator Feature page.
9–30
MN-CDM570A
Revision 3

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Cdm-570alCdmr-570al

Table of Contents