Satellite Modem > Configuration > Cnc (Doubletalk Carrier-In-Carrier) Configuration - Comtech EF Data CDM-570A Installation And Operation Manual

CDM-570A/570AL Satellite Modem with Optional Packet Processor
Optional Packet Processor - Serial/Telnet CLI Operation
9.3.8.1.9 Satellite Modem > Configuration > CnC (DoubleTalk Carrier-in-
Carrier) Configuration
Open the nested CnC (DoubleTalk Carrier-in-Carrier) Configuration page from the Configuration
page.
Selection
CnC Mode
CnC Freq Range/Offset
CnC Min/Max Search
Delay
CnC-APC Max Power
Level Increase
CnC-APC Home State
CnC-APC BER Reset
CnC-APC FER Reset
CnC-APC Activate
CnC-APC Suspend
Figure 9-35. CnC (Carrier-in-Carrier) Configuration
Hot Key Description
M Select the CnC operating mode:
1 – Off
2 – On
3 – APC, Side-A, C-Band
4 – APC, Side-A, X-Band
5 – APC, Side-A, Ku-Band
6 – APC, Side-A, Ka-Band
7 – APC, Side-B, C-Band
8 – APC, Side-B, X-Band
9 – APC, Side-B, Ku-Band
10 – APC, Side-A, Ka-Band
F This value is set depending on the Rx symbol rate as follows:
• 16ksps to 64ksps: ±1 to the symbol rate (ksps)/2
• 64ksps and above: ±1 to 32 kHz
D At the prompts, set the minimum and maximum search delay values, in
milliseconds, in the range from 0 to 300.
P
Set a value in the range from 0.0 to 9.9.
H
B Toggle to reset.
R Toggle to reset.
A Toggle to activate CnC-APC.
U
Toggle to suspend CnC-APC.
See the "AHS" Remote Command/Query in Chapter 8.
SERIAL-BASED REMOTE PRODUCT MANAGEMENT for
details on using this feature.
9–52
MN-CDM570A
Revision 3