Loading Paper In Tray 5 (Bypass Tray) - Fuji Xerox ApeosPort-V C6676 Administrator's Manual

2
Load and align the edge of the paper against
the left edge of the tray, with the side to be
copied or printed on facing up.
Important • Do not load paper above the maximum fill
Note
3
Push the tray in gently until it stops.

Loading Paper in Tray 5 (Bypass Tray)

When printing or copying on a size or type of paper that cannot be set in Trays 1 to 4, use
Tray 5 (bypass tray). The following describes the procedures to load paper in Tray 5. To use
Tray 5 when printing, select Tray 5 and specify the paper type on the [Tray/Output] tab of
the print driver. Also specify the type of paper to be loaded.
Important • To prevent paper jams and erroneous detection of paper loaded in the tray by the machine, do not
Note
1
Open Tray 5.
Note
2
Load paper with the side to be copied or
printed on facing down, inserting the paper
until its edge lightly touches against the paper
feed entrance.
Important • Do not load mixed paper types into the tray.
line ("MAX" in the right figure). It may cause
paper jams or machine malfunction.
• When using punched paper, load the
punched paper as shown in the illustration on
the right.
take out paper of a package until the tray runs out of paper.
• Carefully fan paper before loading it in a tray. Otherwise, the paper may stick together, resulting in
paper jams, or multiple sheets being fed to the machine simultaneously.
• If necessary, pull out the extension tray. The
extension tray can be extended in two stages.
Pull out the extension tray gently.
• Do not load paper above the maximum fill
line. It may cause paper jams or machine
malfunction.
• Depending on the type of the heavyweight
paper, paper may not be fed to the machine
or image quality may deteriorate.
Loading Paper
2
63