Diagnostics; Table B-3. Alarm Trigger Values - Thermo Scientific 146i Instruction Manual

C-Link Protocol Commands

Diagnostics

Diagnostics
B-14 Model 146i Instruction Manual
Table B–3. Alarm Trigger Values
Value Alarm Trigger
0 Floor
1 Ceiling
diag volt mb
This command reports the diagnostic voltage measurements on the
motherboard. The sequence of voltages is: Positive 24, positive 15, positive
5, positive 3.3, and negative 3.3. Each voltage value is separated by a space.
Send: diag volt mb
Receive: diag volt mb 24.1 14.9 4.9 3.2 -3.2
diag volt mib
This command reports the diagnostic voltage measurements on the
measurement interface board. The sequence of voltages is: Positive 24,
positive 15, negative 15, positive 5, positive 3.3. Each voltage value is
separated by a space.
Send: diag volt mib
Receive: diag volt mib 24.1 14.9 -14.9 4.9 3.2
diag volt iob
This command reports the diagnostic voltage measurements on the I/O
expansion board. The sequence of voltages is: Positive 24, positive 5,
positive 3.3, and negative 3.3. Each voltage value is separated by a space.
Send: diag volt iob
Receive: diag volt iob 24.1 4.9 3.2 -3.2
event event params
event = 1-32
This command reports the parameters programmed for the specified event
event.
Send: event 1 params
Receive: event 1 params gas A span 1 ozon 3 perm 1 photo
internal
event status
This command reports the current event that is being executed 1-32. A 0
response indicates no event is currently running.
Send: event status
Receive: event status 1
Thermo Fisher Scientific