Advertisement
C-Link Protocol Commands
Alarms
B-12
Model 146i Instruction Manual
Send:
alarm intensity min
Receive:
alarm intensity min 45000 Hz
set alarm intensity min value
set alarm intensity max value
These commands set the photometer detector intensity minimum and
maximum values to value, where value is a floating-point number
representing intensity alarm limits in hertz. The example below sets the
intensity alarm maximum value to 150000 Hz. These commands are only
available if the photometer option is installed.
Send:
set alarm intensity max 150000
Receive:
set alarm intensity max 150000 ok
alarm internal temp min
alarm internal temp max
These commands report the ambient temperature alarm minimum and
maximum values. The example below reports the internal temperature
alarm minimum value is 15.0 °C.
Send:
alarm internal temp min
Receive:
alarm internal temp min 15.0 deg C
set alarm internal temp min value
set alarm internal temp max value
These commands set the internal temperature minimum and maximum
values to value, where value is a floating-point number representing
ambient temperature alarm limits in degrees C. The example below sets the
internal temperature alarm maximum value to 45.0 °C.
Send:
set alarm internal temp max 45
Receive:
set alarm internal temp max 45 ok
alarm o3 lamp temp min
alarm o3 lamp temp max
These commands report the ozonator lamp temperature alarm minimum
and maximum values. The example below reports the ozonator lamp
temperature alarm minimum value is 52 °C. These commands are only
available if the photometer option is installed.
Send:
alarm o3 lamp temp min
Receive:
alarm o3 lamp temp min 52.0 deg C
set alarm o3 lamp temp min value
set alarm o3 lamp temp max value
These commands set the ozonator lamp temperature alarm minimum and
maximum values to value, where value is a floating-point number
representing ozonator lamp temperature alarm limits in degrees C. The
Thermo Fisher Scientific
Advertisement
Troubleshooting
