Advertisement
Flow Modes
Thermo Fisher Scientific
Note Changing the span concentration may affect allowable limits for total
flow (TFLOW). It is advisable to check this setting.
Detailed information about each of the above options can be found in the
appropriate menu screens. For more information on options, see Chapter 1
"Introduction".
Note If changes are made to the operating parameters via events, C-Link,
or digital inputs, this screen will show the new values, and any unsaved
changes will be lost.
▲
In the Main Menu, choose Operation (or press the OPER soft key)
●
Use
and
●
or setting or change the number in the numeric edit field.
Press
to save the mode, switch to numeric entry, or save the
●
numeric entry.
Use
and
●
numeric edit field.
Press
to return to the Main Menu or
●
screen.
OPERATION:
>GAS A
MANUAL
PERM OFF
OZONE OFF
PHOT OFF
OPER
MODE
The Flow Modes menu allows the user to set the operational mode of the
calibrator in a more intuitive manner than the operation screen. Items
displayed are determined by the options installed. After selecting the
desired mode, a summary screen is displayed to show the new mode and
the user must press
In the Main Menu, choose Flow Modes (or press the MODE soft
●
key)
to move the cursor up and down to select a mode
to change the mode or move the cursor in the
ZFLOW 10000 SCCM
GFLOW
100 SCCM
0.000 PPM
0.0 %
DIAGS ALARM
to activate the new mode.
Operation
Flow Modes
▲
to return to the Run
Model 146i Instruction Manual
3-9
Advertisement
Troubleshooting
