Advertisement
TCP/IP Settings
Thermo Fisher Scientific
The TCP/IP Settings menu is used for defining TCP/IP settings
Note The instrument power must be cycled after this parameter has been
changed for the change to take effect.
In the Main Menu, choose Instrument Controls > Communication
●
Settings > TCP/IP Settings.
Use DHCP
The Use DHCP screen is used to specify whether to use DHCP or not.
In the Main Menu, choose Instrument Controls > Communication
●
Settings > TCP/IP Settings > Use DCHP.
IP Address
The IP Address screen is used to edit the IP address. The IP address can
only be changed when DHCP is on. For more information on DHCP, see
"Use DHCP" above.
In the Main Menu, choose Instrument Controls > Communication
●
Settings > TCP/IP Settings > IP Address.
TCP/IP SETTINGS:
>USE DHCP
IP ADDR
192.168.1.200
NETMASK
255.255.255.0
GATEWAY
HOST NAME
OPER
MODE
DIAGS ALARM
DHCP:
CURRENTLY:
SET TO:
TOGGLE VALUE
CYCLE POWER TO CHANGE DHCP
OPER
MODE
DIAGS ALARM
▲
OFF
0.
0.0.0
iSeries
OFF
ON ?
Model 146i Instruction Manual
Operation
Instrument Controls Menu
3-53
Advertisement
Troubleshooting
