Cli Quick Reference - Alcatel-Lucent OmniSwitch 6250 Cli Reference Manual

CLI Quick Reference

CMM Commands
reload [primary | secondary] [with-fabric] [in [hours:] minutes | at hour:minute [month day |
day month]]
reload [primary | secondary] [with-fabric] cancel
reload working {rollback-timeout minutes | no rollback-timeout} [in [hours:] minutes | at
hour:minute]
[configure] copy running-config working
[configure] write memory
[configure] copy working certified [flash-synchro]
[configure] copy flash-synchro
takeover [with-fabric]
show running-directory
show reload [status]
show microcode [working | certified | loaded]
show microcode history [working | certified]
Chassis Management and Monitoring Commands
system contact text_string
system name text_string
system location text_string
system date [mm/dd/yyyy]
system time [hh:mm:ss]
system time-and-date synchro
system timezone [timezone_abbrev | offset_value | time_notation]
system daylight savings time [{enable | disable} | start {week} {day} in {month} at {hh:mm}
end {week} {day} in {month} at {hh:mm} [by min]]
reload ni [slot] number
reload all [in [hours:] minutes | at hour:minute [month day | day month]]
reload all cancel
reload pass-through slot-number
power ni [slot] slot-number
no power ni [slot] slot-number
temp-threshold temp slot slot-number
stack set slot slot-number saved-slot saved-slot-number [reload]
stack set slot slot-number mode {stackable | standalone} [reload]
stack clear slot slot-number [immediate]
show system
show hardware info
show chassis [number]
OmniSwitch 6250 CLI Reference Guide November 2009
show cmm [number]
show ni [number]
show module [number]
show module long [number]
show module status [number]
show power [supply] [number]
show fan [number]
show temperature [number]
show stack topology [slot-number]
show stack status
show stack mode
Chassis MAC Server (CMS) Commands
mac-range eeprom start_mac_address count
enable | disable
mac-retention status {
mac-retention dup-mac-trap {
mac release
show mac-range [index]
show mac-range [index] alloc
show mac-retention status
Power over Ethernet (PoE) Commands
lanpower start {slot/port[-port2
lanpower stop {slot/port[-port2
lanpower {slot/port | slot} power milliwatts
lanpower slot maxpower watts
lanpower slot/port priority {critical | high | low}
lanpower slot priority-disconnect {enable | disable}
lanpower slot combo-port {enable | disable}
show lanpower slot
show lanpower capacitor-detection slot
show lanpower priority-disconnect slot
Network Time Protocol Commands
ntp server {ip_address | domain_name} [key key | version version | minpoll exponent | prefer]
no ntp server {ip_address | domain_name}
ntp server synchronized
ntp server unsynchronized
ntp client {enable | disable}
ntp broadcast {enable | disable}
ntp broadcast delay microseconds
page 1
}
enable | disable
}
]
| slot}
] | }
slot
CMM Commands