Dldp Reset; Dldp Unidirectional-Shutdown - H3C S3100 Series Command Manual

Note that:
The interval takes effect on all DLDP-enabled ports.
It is recommended that you set the interval shorter than one-third of the STP convergence time
(usually 30 seconds). If too long an interval is set, an STP loop may occur before DLDP shuts down
unidirectional links. On the contrary, if too short an interval is set, network traffic increases,
unnecessarily consuming port bandwidth.
Examples
# Set the interval between sending advertisement packets to 6 seconds for all DLDP-enabled ports in
the advertisement state.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] dldp interval 6

dldp reset

Syntax
dldp reset
View
System view/Ethernet port view
Parameters
None
Description
In system view:
Use the dldp reset command to reset the DLDP status of all the ports disabled by DLDP.
In Ethernet port view:
Use the dldp reset command to reset the DLDP status of the current port disabled by DLDP.
After the dldp reset command is executed, the DLDP status of a port changes from disable to active
and DLDP restarts to detect the link status of the fiber cable or copper twisted pair.
Related commands: dldp and dldp unidirectional-shutdown.
Examples
# Reset the DLDP status of all the ports disabled by DLDP.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] dldp reset

dldp unidirectional-shutdown

Syntax
dldp unidirectional-shutdown { auto | manual }
undo dldp unidirectional-shutdown
1-5