Ipx Server Static - 3Com SuperStack II 9300 Command Reference Manual

C 20: IPX
624
HAPTER

ipx server static

3500
9000
9400
3900
9300
For CoreBuilder 9000: Applies to Layer 3 switching modules only.
Defines a static IPX server.
Valid Minimum Abbreviation
ipx ser st
Important Considerations
Static servers remain in the table until you remove them, until you
remove the corresponding interface, or until you remove the route to
the corresponding network address.
A static server must have an IPX network address that corresponds to
a configured interface or to a static route. If an interface goes down,
any static servers on that interface are permanently removed from the
server table until the interface comes back up.
Static servers take precedence over dynamically learned servers to the
same destination. You can have a maximum of 32 static servers.
Before you define static servers on the system, first define at least one
IPX interface. See "ipx interface define"earlier in this chapter for more
details.
Options
Prompt Description
Interface index Interface index number for the
server
Service type Number for the type of service
that the server performs
Service name Service name of the server, up to
79 characters
IPX network IPX network address of the server 0x0 – 0xfffffffe
address
Socket value Socket value of the server
Node address Node address of the server
Hops Number of hops to the server
Possible Values [Default]
A selectable IPX –
interface index
? (for a list of
selectable IPX
interfaces)
* *
0x1 – 0xffff
Any selectable –
service name
? (for a list of
selectable
names)
–
0x0 – 0xffff –
–
0 – 15 –