Ip Multicast Dvmrp Tunnels Remove - 3Com SuperStack II 9300 Command Reference Manual

ip multicast dvmrp
tunnels remove
3500
9000
9400
3900
9300
For CoreBuilder 9000: Applies to Layer 3 switching modules only.
Deletes a DVMRP tunnel end point from the system.
Valid Minimum Abbreviation
ip m d t r
Important Considerations
To remove a tunnel, specify its tunnel index number. This number is
different from the routing interface index number. Reference the
DVMRP tunnel summary display prior to deleting a tunnel.
If you try to remove an IP interface in your system, and you have a
DVMRP tunnel defined on that interface, the system warns you with
an error message. Before you can remove the IP interface, you must
remove the DVMRP tunnel.
When you remove a tunnel, the system does not dynamically re-order
remaining tunnels in the DVMRP tunnel summary display. For
example, if you had three tunnels with tunnel index numbers 1, 2, and
3 and you then removed tunnel 2, the display lists the remaining
tunnels with their original tunnel index numbers (1 and 3, in this
example). The system assigns tunnel index 2 to the next new tunnel
that you define. After 2 is used, the system can assign tunnel index 4
for the next new tunnel, and so on.
Options
Prompt Description
Multicast Index number of the
tunnel index multicast tunnel that you
want to remove from the
system

ip multicast dvmrp tunnels remove

Possible Values
A valid DVMRP tunnel
index number
? (for a list of selectable
tunnel index numbers)
513
[Default]
–