Ip Rip Routeaggregation Mode - 3Com SuperStack II 9300 Command Reference Manual

3com switch command reference guide

Hide thumbs Also See for SuperStack II 9300:

Table of Contents

routeAggregation

For CoreBuilder 9000: Applies to Layer 3 switching modules only.

Sets the route aggregation mode.

Valid Minimum Abbreviation

Important Considerations

Route aggregation mode determines which route table entries are

sent during a RIP Version 2 update.

If route aggregation mode is

and "collapse" route table entries for all subnets of a directly

connected network. For example, if route aggregation is

and the system is advertising subnets 150.100.31.0 and

150.100.32.0, only the entry for network 150.100.0.0 is sent in

the update. With RIP Version 2, you must enable route aggregation

mode if you want the interface to collapse the route table entries

and function like RIP-1.

If route aggregation mode is

update sends all routing table entries.

IP interfaces

Index number of the interfaces

for which you want to set the

route aggregation mode

Whether you want to

implement route aggregation

on the selected interface

, RIP-2 can function like RIP-1

(the default), a RIP-2

Possible Values

interface indexes

? (for a list of

interface indexes)