Bridge Vlan Modify (3900/9300/9400/ 9000 Layer 2); Bridge Vlan Modify (3500/9000 Layer 3) - 3Com SuperStack II 9300 Command Reference Manual

C 14: V
360
HAPTER IRTUAL
bridge vlan modify
(3900/9300/9400/
9000 Layer 2)
3500
9000
9400
3900
9300
LAN (VLAN )
S S
Changes a port-based VLAN definition on the indicated system Layer 2
module. See "Important Considerations" for information on when
changes take effect.
To use this command on the CoreBuilder 3500 or CoreBuilder 9000
Layer 3 modules, see the "bridge vlan modify (3500/9000 Layer 3)"
earlier in this chapter.
Valid Minimum Abbreviation
b v modi
Important Considerations
You need not reboot the system for the changes to take effect.
However, depending on the number of VLANs that are affected, the
system may take several minutes to return control to you.
If you modify the tagging type of a backplane port on a switching
module, make sure that you modify the tagging type of the
corresponding port on the switch fabric module.
If tagging is enabled for a port, the software uses the VID as the
802.1Q tag.
If you modify the default VLAN, you can only change the member
ports or the tag status. You cannot change the name or the VID.
If you modify the tagging for a port shared by another VLAN, verify
that the new tag type does not conflict with the port's tag type in
another VLAN. (A shared port can use a tag type of
of its VLANs; for all other VLANs to which it belongs, the shared port
must use IEEE 802.1Q tagging.)
Options
Prompt Description
VLAN System-assigned index number that
interface identifies a VLAN
index
for only one
none
Possible Values [Default]
Selectable VLAN 1 (if you
index have only
the default
all
VLAN)
? (for a list of
selectable
indexes)