System Serialport Terminalspeed - 3Com SuperStack II 9300 Command Reference Manual

system serialPort
terminalSpeed
3500
9000
9400
3900
9300
Sets the terminal speed of your system serial port. The terminal speed is
set by changing the terminal connection port baud rates.
Valid Minimum Abbreviation
sy se t
Important Considerations
When you change the terminal port baud rate to something other
than 9600, the new setting becomes the new default, even after you
use the
system nvData reset
You must adjust the baud setting of your terminal or terminal
emulator to match your system serial port's baud rate before you can
reestablish communication using the terminal port.
You can use this command through the terminal serial port or through
a Telnet session. However, if you change the terminal speed while you
are in a Telnet session, you must reboot the system for the change to
take effect.
Options
Prompt Description
Terminal Signal speed for the terminal
speed connection
Confirmation Confirmation of terminal speed
change
Procedure (Local Connection)
1 To set the terminal speed for the serial port, from the top level of the
Administration Console, enter:

system serialPort terminalSpeed

system serialPort terminalSpeed
option.
Possible Values
19200
9600
4800
2400
1200
y (yes)
n (no)
93
[Default]
9600
–