3Com SuperStack II 9300 Command Reference Manual page 349

Prompt Description
Layer 3 Whether you want to define
address Layer 3 information for the IP
configuration VLAN
(IP VLAN
Since this is the last release to
only)
support Layer 3 address
information in IP VLANs, avoid
this mechanism and instead
define multiple IP interfaces
for the VLAN with ip
interface define
commands.
Layer 3 Fields (IP network address and
address and subnet mask) you can use to
mask set up flood domains for
(IP VLAN overlapping IP VLAN
only) subnetworks.
This is the last release to
support Layer 3 address
information in IP VLANs.
Per-port Whether you want to
tagging configure IEEE 802.1Q VLAN
tagging. You are prompted to
answer for each port that you
selected.
Tag type Whether you want to
configure no tagging or IEEE
802.1Q tagging (the VID) for
each port.
VLAN name Unique, user-defined name
that identifies members of the
(for VLANs
VLAN. If you use spaces, put
other than
quotation marks around the
the default)
VLAN name.
Procedure
1 Enter the VLAN identification (VID) number in the range 2 – 4094.
2 Select the bridge ports.
3 Select one or more protocol suites.
If you select an IP protocol suite, proceed with step 4. If you did not
choose an IP protocol suite for this interface, proceed to step 5.
bridge vlan define (3500/9000 Layer 3)
Possible Values
y (yes)
n (no)
Any valid IP
network address
and subnet mask
y (yes)
n (no)
none
802.1Q
Up to 32 ASCII
characters or
spaces
349
[Default]
y
–
y
none
–