Network; Displaying The Server Table; Defining A Static Server - 3Com LANPLEX 2500 EXTENDEDPLEX®2500 EXTENDED User Manual

Displaying the
Server Table
Top-Level Menu
system
interface
ethernet
route
fddi
display
atm server
static
bridge
forwarding
remove
ip
rip
flush
ipx enhanced
sap
appletalk
statistics
snmp
analyzer
script
logout
IPX forwarding is enabled, RIP is active, SAP is active
Interface
2
2
Defining a Static
Server
Top-Level Menu
system
interface
ethernet
route
fddi display
atm server
static
bridge
forwarding
remove
ip
rip
flush
enhanced
ipx
sap
appletalk
statistics
snmp
analyzer
script
logout
You can display the server table for the system to determine which
servers are learned and if they are operational.
To display the contents of the server table, from the Administration
Console top-level menu, enter:
ipx server display
Name Type

Network

GB201 39b 8c141bfe
GB3COM2 39b af0bc60f
Before you define static servers on the system, you must define at least
one IPX interface. See the section "Defining an IPX Interface" on
page 11-3. Static servers remain in the table until you remove them or
until you remove the corresponding interface. Static servers take
precedence over dynamically learned servers to the same destination.
You can have a maximum of eight static servers.
To define a static server:
1 From the Administration Console top-level menu, enter:
ipx server static
2 Enter the interface number of the server.
3 Enter the service type of the server.
4 Enter the service name of the server.
5 Enter the IPX network address of the server.
6 Enter the socket value of the server.
7 Enter the node address of the server.
Administering Servers
Node Socket Hops
08-00-02-04-80-b6
00-00-00-00-00-01
11-9
Age
8059 4 73
85fa 4 85