3Com SuperStack II 9300 Command Reference Manual page 311

5 Enter the trunk name, or to get information about specifying the trunk
name, enter
?
6 Specify whether TCMP is enabled or disabled.
The system indicates that the trunk definition is complete and allows you
to define additional trunks until you reach the system trunk limit.
7 At the system prompt, to define another trunk enter
trunk sequence, enter
You must then reboot to enable the trunks to take effect.
Bridge Trunk Define Example (9000)
The example shows a define operation that creates two trunks.
Select menu option: bridge trunk define
Select mac type {Fast_Ethernet,Gigabit_Ethernet|?}: Fast_Ethernet
Select ports (14-19|all|?): 14-18
Enter mode {100half,100full|?}: 100full
Enter trunk name {?} []: "Trunk_1"
Enter TCMP state (disabled,enabled) [enabled]: enabled
Trunk definition complete
Define another trunk? (y,n) [n]: y
Select mac type {Fast_Ethernet,Gigabit_Ethernet|?}: Fast_Ethernet
Select up to 8 ports (1-12|?): 1-6
Enter trunk name {?} []: Trunk2
Enter TCMP state (disabled,enabled) [enabled]:enabled
Trunk definition complete
The configuration of the ports will be modified.
The system must be rebooted to complete trunk configuration.
This may take a few minutes.
Are you sure you want to reboot the system? (n,y) [y]: y
(no).
n
bridge trunk define 311
(yes) or to end the
y