Bridge Vlan Define (3500/9000 Layer 3) - 3Com SuperStack II 9300 Command Reference Manual

bridge vlan define
(3500/9000 Layer 3)
3500
9000
9400
3900
9300
For CoreBuilder 9000: Applies to Layer 3 switching modules only.
Creates a VLAN on the CoreBuilder 3500 system or a CoreBuilder 9000
Layer 3 module. When you explicitly configure a VLAN on the system, you
assign information such as a VLAN ID (VID), a set of bridge ports, and,
optionally, a protocol type and IEEE 802.1Q tagging.
For details about this command on the SuperStack II Switch 3900, the
Switch 9300, the CoreBuilder 9400, and CoreBuilder 9000 Layer 2
modules, see "bridge vlan define (3900/9300/9400/ 9000 Layer 2)" next.
Valid Minimum Abbreviation
b v def
Important Considerations
If you have previously defined your IP VLANs with Layer 3 address
information (that is, network-based VLANs), you can redefine your IP
VLANs without Layer 3 address information. To define multiple IP
interfaces per IP VLAN, use the
Chapter 16.)
The VLAN that you create with this command is a static VLAN. To
establish routing between static IP VLANs, define your IP VLANs and
then use the
ip interface define
interface. As of Release 3.0, you can also specify the interface type
to create one or more IP routing interfaces for a static IP VLAN.
vlan
If you have a router port IP interface on the system, you cannot specify
the port that belongs to the router port IP interface when you
explicitly define an IP VLAN (or a VLAN that includes the IP protocol). A
router port IP interface is an alternative to static VLANs and allows
routing versus bridging. You create a router port IP interface by
entering the
ip interface define
and a single bridge port. A router port IP interface requires
port
allClosed mode. See Chapter 16 for more information.

bridge vlan define (3500/9000 Layer 3)

ip interface define
command to define an IP routing
command with the interface type
345
command. (See