Ip Ospf Partition Display - 3Com SuperStack II 9300 Command Reference Manual

ip ospf partition
display
3500
9000
9400
3900
9300
For CoreBuilder 9000: Applies to Layer 3 switching modules only.
Displays OSPF memory allocation.
Valid Minimum Abbreviation
ip o pa d
Important Consideration
See "ip ospf partition modify" later in this chapter for information on
how OSPF memory allocation works and how to modify it.
Fields in the IP OSPF Partition Display
Field Description
Current partition OSPF memory partition upper limit as implemented at the last
maximum size system reboot.
Configured Last value that you entered, which will become the current
partition partition maximum size after the next system reboot.
maximum size
0 means that OSPF has been set to use the system memory
partition at the next reboot.
1 means that OSPF has been set to use the default memory
allocation scheme, deriving its partition size from the
maximum size of the IP routing table at the next reboot.
Any other value that does not equal the current partition
maximum size means that OSPF has been manually set to use
a specific maximum partition size at the next reboot.
Allocated Module's current working memory. OSPF dynamically allocates
partition size memory in 100,000-byte chunks, up to the current partition
maximum size.
OSPF is using the The administrator used the ip ospf partition modify
system partition command to set a partition value of 0. The OSPF protocol is using
the system memory partition instead of its own partition, and
there is no specified OSPF memory limit.

ip ospf partition display

569