Ipx Route Static - 3Com SuperStack II 9300 Command Reference Manual

C 20: IPX
618
HAPTER

ipx route static

3500
9000
9400
3900
9300
For CoreBuilder 9000: Applies to Layer 3 switching modules only.
Defines a static route.
Valid Minimum Abbreviation
ipx ro st
Important Considerations
Before you define static routes on the system, define at least one IPX
interface. See "ipx interface define" earlier in this chapter for more
details.
Static routes remain in the routing table until you remove them or
until you remove the corresponding interface.
If an interface goes down, routes are temporarily removed from the
routing table until the interface comes back up.
Static routes take precedence over dynamically learned routes to the
same destination. You can have a maximum of 32 static routes.
Options
Prompt Description
IPX network 4-byte IPX address of the
address interface. The address must be
unique within the network.
Hops Number of hops, or number of
routers that must be crossed to
reach the network segment.
Interface Interface number to associate
number with the route. Depends on
number of configured IPX
interfaces.
Node address 6-byte MAC address of the
router that can forward packets
to the segment. A node address
of all zeroes
(00-00-00-00-00-00) means
that the route is connected
directly to the router.
Possible Values [Default]
0x1 – 0xfffffffe –
1 – 15 1
A selectable –
IPX interface
number
? (for a list of
selectable IPX
interfaces)
A node address –
in the format
xx-xx-xx-xx-xx-xx