Bridge Port Stpstate - 3Com SuperStack II 9300 Command Reference Manual

bridge port stpState

3500
9000
9400
3900
9300
Sets the Spanning Tree Protocol (STP) state for one or more bridge ports.
The selection is effective only if STP is enabled for the system or module.
Valid Minimum Abbreviation
b po stps
Important Considerations
You can use this command to configure the same setting on multiple
ports simultaneously. When you specify multiple port numbers, the
system prompts you to choose the setting and then applies it to all of
the ports.
The following table explains the forwarding behavior of a port based
on its bridge and port STP states:
Bridge STP State Port STP State
Disabled Disabled
Enabled
Removed
Enabled Disabled
Enabled
Removed
Options
Prompt Description
Ports Ports for which you want
to control the STP setting
STP state Spanning Tree Protocol
state that you assign to
specified ports
bridge port stpState
Port Participates Port Forwards
in STP? Frames?
No Yes, if link state is up.
No Yes, if link state is up.
No Yes, if link state is up.
No No
Yes Determined by STP,
provided that the
port link state is up.
No Yes, if link state is up.
Possible Values [Default]
One or more –
valid port
numbers
? (to display a
port summary)
enabled enabled (factory
default), or current
disabled
value
removed
289