Bridge Packetfilter Load - 3Com SuperStack II 9300 Command Reference Manual

bridge packetFilter
load
3500
9000
9400
3900
9300
For CoreBuilder 9000: Applies to Layer 3 switching modules only.
Transfers a packet filter file from another host machine to the switch to
which you are currently connected.
Valid Minimum Abbreviation
b pa lo
Important Considerations
On the CoreBuilder 3500, before you use the packetFilter load
command, select the required file transfer protocol (TFTP or FTP) using
the
system fileTransfer
On the CoreBuilder 3500, this single command transfers a file from
another host and loads it in a one-step process.
On the CoreBuilder 9000, loading a filter from another host is a two-
step process. You must first download the packet filter source file to
the Enterprise Management Engine (EME) using TFTP, then
the Layer 3 module, then enter this
command.
The syntax of the EME download command is:
download module <slot.subslot> filter <IP address> <filename>
You must use TFTP to download on the CoreBuilder 9000. FTP does
not work.
When you enter

bridge packetFilter load

does not prompt you for any options. Instead, the module simply
looks for the downloaded filter on the EME. If it finds it, it loads it. If it
does not find it, it prints the message
TFTP or FTP hosts may place restrictions on which files and pathnames
are valid. See your host administrator or host documentation for TFTP
and FTP information.
bridge packetFilter load
syntax is correct, it stores the filter into non-volatile memory. If the
syntax is incorrect, you are prompted to enter the built-in editor so
that you can fix the filter.
bridge packetFilter load
command.
bridge packetFilter load
, the CoreBuilder 9000
Filter not found
verifies the syntax of the filter. If the
379
to
connect
.