Accessing Your System - 3Com SuperStack II 9300 Command Reference Manual

C 1: A
36
HAPTER DMINISTRATION
Accessing Your
System
O
VERVIEW
You access the Administration Console for your system in one of two
ways:
For all systems except the CoreBuilder 9000 — Access the
Administration Console for the first time at the Administer level and
press Return at the password prompt (the initial password is null).
Subsequently, every time that you access the Administration Console,
it prompts you for an access level and password, as shown here:
Select access level (read, write, administer):
Password:
The passwords are stored in nonvolatile (NV) memory. You must enter
the password correctly before you can continue.
For the CoreBuilder 9000 — On this system, the Enterprise
Management Engine (EME) controls passwords and access levels to
manage the chassis and its installed modules.
To access a module in a CoreBuilder 9000 system, follow these steps:
1 Log in to the EME.
2 Access the module that you want to manage using the EME connect
command.
Example: To connect to a module in slot 10, subslot 1, enter:
connect 10.1
All modules use subslot 1.
The system displays a prompt similar to the following:
CB9000@slot10.1 [20-E/FEN-TX-L2]
When you have connected to a module, you manage the module from
the Administration Console with the same level of access that you have
on the EME. For example, if you have logged in to the EME with
administer privileges, you also have administer privileges for the module
to which you are connected.
For additional information about the EME, see the CoreBuilder 9000
Enterprise Switch Getting Started Guide and the CoreBuilder 9000
Enterprise Management Engine User Guide.