3Com SuperStack II 9300 Command Reference Manual page 125

Example Script (3500)
This example scripts these tasks to initially configure your system:
Changes the modem port baud
Sets the system name
Assigns an IP address for management
Verifies the IP connection by pinging the system
Enables Spanning Tree
Sets up SNMP trap reporting
# This script performs some start-up configurations.
#
# Set the modem serial port baud.
#
system serialPort modemSpeed
4800 # modem serial port baud
#
# Set the system name
#
system name
Eng_CoreBuilder_4
#
# Assign an IP address to the system.
#
ip interface define
158.101.112.99 # IP address for the system
255.255.0.0 # subnet mask
1 # VLAN interface index
ip interface summary all
#
# Validate access to management workstation
#
ip ping
158.101.112.26 # management workstation address
#
# Enable the Spanning Tree Protocol
#
bridge stpState enabled
#
# Configure my node as an SNMP trap destination
#
snmp trap add
158.101.112.26 # management workstation address
all # turn on all traps
q # no more trap destinations
#
snmp trap display
#
script 125