Ip Route Static - 3Com SuperStack II 9300 Command Reference Manual

C 16: I
422
HAPTER NTERNET

ip route static

3500
9000
9400
3900
9300
P (IP)
ROTOCOL
For CoreBuilder 9000: Applies to Layer 3 switching modules only.
Defines a static route.
Valid Minimum Abbreviation
ip route s
Important Considerations
Before you can define static routes, you must define at least one IP
interface. See "ip interface define (3500/9000 Layer 3)" earlier in this
chapter for more information.
For the CoreBuilder 3500, you can define up to 256 static routes.
For the other platforms, you can define up to 64 static routes.
Static routes remain in the table; you must remove them before you
can remove the corresponding interface.
Static routes take precedence over dynamically learned routes to the
same destination
Static routes are included in periodic Routing Information Protocol
(RIP) updates that the system sends.
Options
Prompt Description
Destination IP IP address of the
address destination network,
subnetwork, or host
for this route
Subnet mask Subnet mask for the
specified IP address
Gateway IP IP address of the
address gateway that this
route uses
Possible Values
A valid IP address
A valid subnet mask
A valid router address
[Default]
–
Based on
specified IP
address
–