Bridge Trunk Automap Enable/Disable - 3Com SuperStack II 9300 Command Reference Manual

C 11: T
302
HAPTER RUNKS
bridge trunk
autoMap
enable/disable
3500
9000
9400
3900
9300
Dynamic backplane trunking provides automatic backplane trunking on
the switch fabric modules and managed interface modules.
Valid Minimum Abbreviation
b t a e
Important Considerations
You can enable or disable the autoMap function on slots.
All trunking is performed through the switch fabric module.
Do not perform backplane trunking through the interface modules.
When you enable autoMap on a module in a specific slot, the switch
fabric module verifies that the switch fabric module and the interface
module's backplane configuration support dynamic backplane
mapping.
When you disable autoMap on a module in a specific slot, the switch
fabric module verifies that the interface module's backplane
configuration is compatible with that of the switch fabric module's
backplane.
Options
Prompt Description
Slot number Slot number to choose to
enable or disable autoMap
function
Possible Values [Default]
One slot number –