Bridge Trunk Remove - 3Com SuperStack II 9300 Command Reference Manual

C 11: T
318
HAPTER RUNKS

bridge trunk remove

3500
9000
9400
3900
9300
Removes a previously defined trunk. You can remove one or more trunks
with this command.
Valid Minimum Abbreviation
b t r
Important Considerations
The number of trunk groups and the number of ports within a trunk
group depend on your system. See the Options table. However,
because each Gigabit Ethernet module uses an internal trunk resource
towards the limit of four (Gigabit Ethernet only), keep in mind how
many trunk resources you have when you remove trunks. For example,
if you have a trunk with two Gigabit Ethernet ports (which
consolidates two Gigabit trunk resources into one) as well as three
other trunks, and you then try to remove the Gigabit Ethernet trunk,
you will exceed the trunk resource limit. (The Gigabit Ethernet ports
use two trunk resources.) The system reports that it is unable to
remove the trunk because the trunk resource limit would be exceeded.
Removing a trunk requires a module reboot. For CoreBuilder 9000
modules, rebooting a module returns you to the EME prompt, which
requires you to reconnect to the module.
Options
Prompt Description
Trunk index Index number of the trunk that
you want to remove
Possible Values [Default]
One or more –
valid trunk
index number
all
? (for a list of
selectable trunk
indexes)