Bridge Vlan Stpmode - 3Com SuperStack II 9300 Command Reference Manual

bridge vlan stpMode

3500
9000
9400
3900
9300
selection
1
2
Select VLAN interface index(es) (1-2|all|?):2
Ignore STP state for VLAN index: 2 (disabled,enabled) [disabled]:enabled
For CoreBuilder 9000: Applies to Layer 3 switching modules only.
If allClosed mode is enabled, allows the system to ignore the Spanning
Tree Protocol (STP) state for a specified VLAN interface or all interfaces,
for either routing or bridging.
Valid Minimum Abbreviation
b v st
Important Considerations
This mode is valid only if the VLAN mode is set to
To disable the STP state on a per-port basis with either allOpen or
allClosed mode, use the
Chapter 10.
If you have configured router port IP interface (and therefore have a
router port VLAN), the ignore STP mode is enabled and cannot be
changed. You cannot select a router port VLAN with this command.
Options
Prompt Description
VLAN System-assigned index number that
interface is associated with the VLAN
index
STP state Whether you want to ignore the STP
state for the VLAN index
Bridge VLAN STP Mode Example (3500)
VID ports
1 1-13
2 3,5-9,11
bridge vlan stpMode
bridge port stpState
Possible Values [Default]
name
Default
IP1
365
.
allClosed
command. See
Any –
selectable
VLAN index
number
all
? (for a list of
selectable
indexes)
disabled disabled
enabled