Bridge Vlan Modify (3500/9000 Layer 3) - 3Com SuperStack II 9300 Command Reference Manual

bridge vlan modify
(3500/9000 Layer 3)
3500
9000
9400
3900
9300
For CoreBuilder 9000: Applies to Layer 3 switching modules only.
Changes an existing port-based, protocol-based, or network-based VLAN
definition on the CoreBuilder 3500 system or CoreBuilder 9000 Layer 3
module.
To use this command on the SuperStack II Switch 3900 or Switch 9300,
the CoreBuilder 9400, and CoreBuilder 9000 Layer 2 modules, see
"bridge vlan modify (3900/9300/9400/ 9000 Layer 2)" next.
Valid Minimum Abbreviation
b v modi
Important Considerations
Before you modify the port assignments for a VLAN, always enter
review the system port summary. If the VLAN includes trunk ports, you
must specify the anchor (lowest numbered) port in each trunk. If there
are no trunk ports, enter one or more port numbers, or enter
assign all ports to the VLAN.
For the CoreBuilder 3500, if you want to modify your VLAN to include
FDDI DAS ports, you must specify the lowest-numbered port in the
DAS pair.
If you modify the default VLAN, you can only change the member
ports or the tag status. You cannot change the name or the VID or the
protocol type of unspecified.
If you modify the tagging type of a backplane port on a switching
module, make sure that you modify the tagging type of the
corresponding port on the switch fabric module.
To modify a VLAN to support more than one protocol suite for the
VLAN, specify one protocol at each of the prompts.
Select the bridge ports that you want to be part of the modified
VLAN, or specify
?
bridge ports.
If tagging is enabled for a port, the software uses the VID as the
802.1Q tag.

bridge vlan modify (3500/9000 Layer 3)

to display a port summary with the selectable
355
to
?
to
all