Ip Multicast Dvmrp Default - 3Com SuperStack II 9300 Command Reference Manual

C 18: IP M
520
HAPTER
ip multicast dvmrp
default
3500
9000
9400
3900
9300
ULTICAST
For CoreBuilder 9000: Applies to Layer 3 switching modules only.
Configures a default route for IP multicast traffic on a DVMRP interface.
This interface advertises itself as a default route to neighboring DVMRP
routers.
Valid Minimum Abbreviation
ip m d d
Important Considerations
A default route metric of 0 means that the default route function is
not activated on the interface (interface does not advertise 0.0.0.0 to
DVMRP routers). Values other than 0 means that the default route
function is activated and these values represent the "cost" of the
default route.
Definitions of default route modes:
all — The interface advertises the default route plus all other
known routes to neighboring DVMRP routers.
only — The interface advertises only the default route to
neighboring DVMRP routers.
If the system learns a default route, it propagates it no matter which
mode is set on a given interface.
The system allows you to configure an interface as a DVMRP default
route, even when DVMRP is disabled on the interface. If DVMRP is
disabled, the interface does not advertise itself as a default route.
Options
Prompt Definition
interface Index number of the routing
interface on which you want to
configure a default route
default Value that you assign to the
route metric default route as the "cost" of
that route
default Routes that the interface
route advertises to neighboring
advertise DVMRP routers
mode
Possible Values [Default]
A valid interface 1 (factory
index number default), or
current value
? (for a list of
selectable
indexes)
0 – 32 0 (factory
default), or
current value
all all (factory
default), or
only
current value