Ip Rip Compatibilitymode - 3Com SuperStack II 9300 Command Reference Manual

ip rip
compatibilityMode
3500
9000
9400
3900
9300
For CoreBuilder 9000: Applies to Layer 3 switching modules only.
On a per-interface basis, sets the RIP Version 1 compatibility mode.
Valid Minimum Abbreviation
ip ri com
Important Considerations
The RIP-1 compatibility mode determines how the software sends
periodic RIP-2 updates. (For RIP-1, the software never uses the
multicast address; it uses the advertisement list.)
When the system is configured to advertise RIP-2 packets and
compatibility mode is
address of 224.0.0.9 when sending periodic updates. This latest
industry recommendation reduces the load on hosts that are not
configured to listen to RIP-2 messages.
When the system is configured to advertise RIP-2 packets and
compatibility mode is
advertisement list for RIP-2 updates.
Options
Prompt Description
IP interfaces Index number of the interfaces
for which you want to set the RIP
compatibility mode
RIP-1 Selected RIP Version 1
compatibility compatibility mode that
mode determines how the system
handles RIP-2 updates

ip rip compatibilityMode

, the software uses the multicast
disabled
, the software uses the
enabled
Possible Values
One or more
selectable
interface
indexes
all
? (for a list of
selectable
interface
indexes)
disabled
enabled
455
[Default]
Previous
entry, if
applicable
disabled