Bridge Packetfilter Create Portgroup - 3Com SuperStack II 9300 Command Reference Manual

bridge packetFilter
create portGroup
3500
9000
9400
3900
9300
For CoreBuilder 9000: Applies to Layer 3 switching modules only.
Creates the portGroup (rejdiffportgroup) standard hardware filter.
Valid Minimum Abbreviation
b pa c p
Important Considerations
The portGroup (rejdiffportgroup) packet filter rejects a frame if the
destination and source ports are not in the same group.
"Creating" a hardware filter means that the code for the filter is
copied from firmware into non-volatile memory.
To verify that the filter has been created, use the
packetFilter list
filter, use the
bridge PacketFilter display
The system only creates the packet filter definition. You must still
assign ports and masks to port groups, as described for "bridge
packetFilter portGroup create" later in this chapter, and assign the
standard filter to ports and filtering paths, as described for "bridge
packetFilter assign" later in this chapter.
At present, portGroup is the only filter supported in hardware.
Bridge Packet Filter Create Port Group Example
This example shows the user creating the portGroup filter.
Select menu option (bridge/packetFilter): create portgroup
Packet filter 1 stored.

bridge packetFilter create portGroup

command. To see the contents of the portGroup
373
bridge
command.