3Com SuperStack II 9300 Command Reference Manual page 404

C 16: I
404
HAPTER NTERNET
P (IP)
ROTOCOL
Options
Prompt Description
IP address IP address of the interface, chosen
from the range of addresses that
the central agency assigned to your
organization. This address is specific
to your network and system.
Subnet mask 32-bit number that uses the same
format and representation as an IP
address. The subnet mask
determines which bits in the IP
address are interpreted as the
network number, the subnetwork
number, and the host number.
Each IP address bit that corresponds
to a 1 in the subnet mask is in the
network/subnetwork part of the
address. Each IP address bit that
corresponds to a 0 is in the host
part of the IP address.
Interface type Whether to use router port-based
routing or VLAN-based routing.
VLAN mode Whether the system removes all
(for router VLANs and recreates the default
port-based VLAN to enable port-based routing.
routing)
Bridge port (for Port to use for port-based routing
router (may designate only one port).
port-based
routing)
VLAN interface Index number of the IP VLAN that is
index (for associated with the IP interface; for
VLAN-based a VLAN-based IP interface, you
routing) must assign this number. (Not
applicable if you have more than
one VLAN)
Possible Values [Default]
A valid IP address –
in the range of
addresses that
are assigned to
your
organization
A valid subnet Depends
mask in on
accordance with specified IP
the bits that are address
used for network
number,
subnetwork, and
host number
port vlan
vlan
n (no) y
y (yes)
1 – n –
? (for a list of
selectable
ports)
A selectable Next
VLAN index available
index
? (for a list of
number
selectable
VLAN
indexes)