Ip Interface Modify - 3Com SuperStack II 9300 Command Reference Manual

ip interface modify

3500
9000
9400
3900
9300
For CoreBuilder 9000: Applies to Layer 3 switching modules only.
Changes the configuration of an interface that you have already defined.
Valid Minimum Abbreviation
ip i m
Important Consideration
On the CoreBuilder 3500, you cannot modify the port number (router
port-based routing) after it has been defined because of the
associated virtual LAN (VLAN); you must remove the interface and
then redefine it.
Options
Prompt Description
IP interface Index number that is associated
with the interface that you want
to modify.
(Not applicable if you have more
than one interface)
IP address IP address of the interface that
you want to modify.
Subnet mask Subnet mask for the interface
that you want to modify.
VLAN interface Index number of the IP VLAN
index (for that is associated with the IP
VLAN-based interface; for a VLAN-based IP
routing) interface, you must assign this
number.
(Not applicable if you have more
than one VLAN)
ip interface modify
Possible Values [Default]
A selectable IP Current
interface index value
? (for a list of
selectable
indexes)
A valid IP address Current IP
in the range of address
addresses that are
assigned to your
organization
A valid subnet Current
mask in subnet
accordance with mask
the bits that are
used for network
number,
subnetwork, and
host number
A selectable Current
VLAN index value
? (for a list of
selectable
VLAN indexes)
407