Bridge Port Detail - 3Com SuperStack II 9300 Command Reference Manual

bridge port detail

3500
9000
9400
3900
9300
Displays detailed information about bridge ports, including the Spanning
Tree Protocol (STP) configurations for the bridge port.
Valid Minimum Abbreviation
b po d
Important Considerations
The port numbering that is displayed for your ports is always
sequential, although it depends on the placement of the modules that
you have configured into your system. See the Implementation Guide
for your system for more information about port numbering.
For resilient links, the main and standby ports are shown in ascending
order.
When you are prompted to select ports, specify the
list of information about your bridge ports. This matrix is useful, for
example, if you have trunks configured but forget which port is the
anchor port. You must use the anchor port number to display a port
summary for a trunk.
Fields in the Bridge Port Detail Display
Field
designatedBridge
designatedCost
designatedPort
designatedRoot
fwdTransitions
gvrpState
(3500, 9000 L3)
Description
Identity of the designated bridge of the LAN to which the
port is attached. It is an STP port parameter.
Cost through this port to get to the root bridge. The
designated cost of the root port is the same as the cost
that is received in incoming BPDUs from the designated
bridge for that LAN. It is an STP port parameter.
Identity of the designated port on the designated bridge.
Identity of the root bridge in the LAN, which includes the
root bridge's priority value and the MAC address of port 1
on that bridge.
Number of times that the port has entered the forwarding
state since you enabled STP or rebooted the system. This
value is useful for determining the relative stability of the
topology.
Whether the GARP VLAN Registration Protocol (GVRP) is
enabled or disabled on the port. For GVRP to function on
the port, you must enable it on the port as well as the
entire bridge. To configure GVRP on a port, see "bridge
port gvrpState" in this chapter. To configure GVRP on the
bridge, see "bridge gvrpState" in Chapter 9.
bridge port detail 283
option to see a
?