Table of Contents
Advertisement
Important: Note that the IP addresses on the PBX
have also been reset to factory settings. This means
you
now
need
to
configuration. See
Page
had been configured as a DHCP client (DHCP on),
this setting has been retained.
Fig. 63: LEDs and buttons
DEFAULT
Status
Reset
Requirements
– Opened configuration manager (with an existing con-
nection to the PBX web server)
– Connection
via
broadband
(for example, a DSL connection)
– The address of the update server registered on the
page Administration
www.auerswald-update.de
– The address of the DNS server registered on the
page Administration
– The number of the update server entered in the tele-
phones, if you would like to perform a firmware
update of the system telephones. See the telephone
manual.
Important: When performing a firmware update, the
PBX should be in the idle state.
Steps to Take
1.
Open the page Administration
restart.
Note: Under Instant firmware update via update
server, enable the checkbox for COMfortel firmware
update if you would also like to perform a firmware
update for the system telephones.
2.
Click Update.
The "Status" LED and the "Power" LED are lit in
green during data transmission.
reconfigure
the
network
55. Exception: If the PBX
Performing an Immediate Firmware Update
Internet
access
Server configuration:
Server configuration
Firmware update/
Service and Maintenance
The "Status" LED and the "Power" LED light up in
red and orange for several seconds/minutes
during the restart. See also the table on
If both LEDs light up in green again, the restart is
complete and the PBX is ready for operation.
Further Steps
In order to use new features after a firmware update,
you normally need a new version of the operating
manual and the configuration manual. Both are
available per download from the support pages at the
Auerswald
web
www.auerswald.de).
Fig. 64: "Power" LED
Power
Page
site
(Internet
address:
71.
77
Advertisement
Table of Contents
