Default-Information Originate (Rip); Default-Metric (Rip); Distance Rip - NETGEAR GSM7228PS Cli Manual

default-information originate (RIP)

This command is used to control the advertisement of default routes.
Format
default-information originate
Mode Router RIP Config
no default-information originate (RIP)
This command is used to control the advertisement of default routes.
Format
no default-information originate
Mode Router RIP Config

default-metric (RIP)

This command is used to set a default for the metric of distributed routes.
Format
default-metric <0-15>
Mode Router RIP Config
no default-metric (RIP)
This command is used to reset the default metric of distributed routes to its default value.
Format
no default-metric
Mode Router RIP Config

distance rip

This command sets the route preference value of RIP in the router. Lower route preference values
are preferred when determining the best route. A route with a preference of 255 cannot be used to
forward traffic.
Default 15
Format
distance rip <1-255>
Mode Router RIP Config
Routing Commands
Managed Switch CLI Manual, Release 8.0.3
v1.0, July 2010
4-84