Distance Rip; Default-Information Originate (Rip); Default-Metric (Rip) - NETGEAR ProSafe GSM7224P User Manual

default-information originate (RIP)

This command is used to control the advertisement of default routes.
Format
default-information originate
Mode
Router RIP Config
no default-information originate (RIP)
This command is used to control the advertisement of default routes.
Format
no default-information originate
Mode
Router RIP Config

default-metric (RIP)

This command is used to set a default for the metric of distributed routes.
Format
default-metric <0-15>
Mode
Router RIP Config
no default-metric (RIP)
This command is used to reset the default metric of distributed routes to its default value.
Format
no default-metric
Mode
Router RIP Config

distance rip

This command sets the route preference value of RIP in the router. Lower route preference
values are preferred when determining the best route. A route with a preference of 255
cannot be used to forward traffic.
Default
15
Format
distance rip <1-255>
Mode
Router RIP Config
no distance rip
This command sets the default route preference value of RIP in the router.
Format
no distance rip
Mode
Router RIP Config
ProSafe Managed Switch
Routing Commands
310