Starting The Test Run - HEIDENHAIN TNC 620 User Manual

1
First Steps with the TNC 620
1.4 Graphically testing the first part (Advanced Graphic Features
software option)

Starting the test run

Press the RESET + START soft key: The TNC
simulates the active program up to a programmed
break or to the program end
While the simulation is running, you can use the
soft keys to change views
Press the STOP soft key: The TNC interrupts the
test run
Press the START soft key: the TNC resumes the
test run after an interruption.
Further information on this topic
Running a test run: See "Test Run", page 513
Graphic functions: See "Graphics (Advanced Graphic Features
software option)", page 502
Adjust the simulation speed: See "Speed of the Setting test
runs", page 503
60
TNC 620 | User's Manual
HEIDENHAIN Conversational Programming | 3/2014