Saving And Loading Recordings - HEIDENHAIN iTNC 530 Service Manual

Explanation of the soft keys:
Explanation of the soft keys:
8.3

Saving and Loading Recordings

You can display the signal last recorded for a channel again by selecting the Saved signal.
With the SAVE SCREEN soft key in the Setup menu you can save the recorded signals with all
settings in a file on the hard disk. The file must have the extension *.DTA.
This file can
To read in a *.DTA file in the control again:




May 2006
Hide/show gridlines.
Hide/show lines between measured points.
Start recording. Recording is finished either by a trigger condition
or by pressing the soft key STOP.
Move the signal down.
Move the signal up.
Decrease vertical resolution.
Increase vertical resolution.
Optimum vertical resolution. The signal is centered in the middle
of the screen.
Optimum vertical resolution. The signal is referenced to the
datum line.
Switch to second cursor.
Move the signal to the left.
Move the signal to the right.
Decrease horizontal resolution.
Increase the horizontal resolution.
The signal is inverted.
Terminate the oscilloscope function.
be recalled with the PLC development software PLCdesign
be read in again into the control
Press the RESTORE SCREEN softkey in the setup menu
Enter the complete file name and path of the *.DTA file.
Press the ENT key.
Press the OSCI, softkey to display the signals of the *.DTA file.
8 – 53