Signal Generator Subsystem; Rfgenerator Subsystem Command Reference; Table 5-13 Rfch Allowable Range And Preset Value - Agilent Technologies N9360A Programming Manual

5
Programming Command Reference

Signal Generator Subsystem

RFGenerator Subsystem Command Reference

5-72
• <real 3> (up to 4 letters) is the measured data ranging
from to
0.00 9.99
range or OBW is not measured, the value
This command is valid only when the W07 option is installed in
the Tester. If the W07 option is not installed in the Tester, an
execution error occurs.
The Signal Generator subsystem commands are used to set and
read the controls and parameters of the Signal Generator
functions.
Radio System
RFGenerator:RFORmat W_CDMA
RFGenerator:RFORmat?
This command selects a Radio System to be tested. Only
is available.
RFCH
RFGenerator:CHANnel <int>
RFGenerator:CHANnel?
This command sets the channel number. The allowable range
and preset values are as follows:

Table 5-13 RFCH Allowable Range and Preset Value

Band Allowable Range
1 10550 to 10850
6 4375 to 4425, 1037, 1062
The range of the value is same as that of the command
parameter.
RFGenerator:CHANnel <int 1>,<int 2>
N9360A Multi UE Tester W-CDMA Programming Manual
in MHz. If measurement result is out of
is returned.
9.99
W-CDMA
Preset Value
10562
4387