Creating A Smlt From An Existing Mlt - Avaya 8600 Configuration Manual

MLT and SMLT link aggregation configuration using the CLI
info
key <integer>
min-link <integer>
<mlt id>
system-priority <integer>

Creating a SMLT from an existing MLT

Create a SMLT from an existing MLT to split physical ports between two switches, which
provides active load sharing and high availability.
Prerequisites
• Create an MLT before you create a split in the MLT.
Procedure steps
1. Create a SMLT from an existing MLT by using the following command:
100 Configuration — Link Aggregation, MLT, and SMLT
Variables
Comments? infodev@avaya.com
Value
Shows current level parameter settings and
next level directories.
Sets LACP aggregator key for a specific
MLT.
• integer is the LACP key.
Important:
If you set the key to 0, any LACP-enabled
port with a non-matching key will be
allowed to join the LAG.
Configures the minimum number of active
links (MinLink) required for the LAG to
remain in forwarding state. If the number of
active links falls below this number, the
Avaya Ethernet Routing Switch 8800/8600
declares the entire LAG down.
The default value is 1.
Specifies the MLT ID.
Sets LACP system priority for a specific
MLT.
• integer is the system priority within the
range 0–65535.
The default value is 32768.
January 2012