Troubleshooting layer 2 and layer 3
3. Review the command output details under the L3 section.
Enabling or disabling Proxy ARP using EDM
Procedure
1. Navigate to IP Routing > IP > ARP Interface.
2. Select an interface from the list.
3. Set the desired value in the DoProxy field.
Enabling or disabling proxy ARP using SNMP
You can use SNMP to enable or disable proxy ARP.
Procedure
1. Enter the SNMP set command on the rcArpExtEntDoProxy object.
2. Review the command output for errors.
Using ASCII Configuration Generator to check proxy ARP configuration
About this task
You can use the ASCII Configuration Generator (ACG) to check proxy ARP configuration.
Procedure
1. Enter the command show running-config.
2. Review the command output under the following subsections:
Failure to establish OSPF adjacency
You may need to correct the OSPF parameters to ensure that adjacencies are established.
150
Troubleshooting
• no ip arp proxy [enable] command to disable proxy ARP
• default ip arp proxy [enable] command to set proxy ARP to the
default value
• L3 Protocols
• Proxy ARP
Comments? infodev@avaya.com
December 2013