MLT and SMLT link aggregation configuration using Enterprise Device Manager
14. In the SmltId box, type an unused SMLT ID.
15. In the Multicast Distribution box, select one of the following:
16. Select or clear NtStgEnable check box.
17. In the Aggregatable box, select one of the following:
18. In the AggMinLink box, configure the number of active links required for this LAG
19. Click Insert.
20. Click Close.
Viewing MLT-based SMLTs
Use MLT-based SMLTs to view the MLT-based SMLT configuration.
Note:
If you disable and enable the SMLT or IST ports, the designated port information may not
appear correctly.
Procedure steps
1. In the navigation tree, open the following folders: Configuration > VLAN.
2. Click SMLT.
3. Click the SMLT Info tab.
72
Configuration — Link Aggregation, MLT, and SMLT
The corresponding SMLT between aggregation switches must have matching SMLT
IDs. The same ID number must be configured on both switches.
• enable
• disable
• enable
• disable
to remain in the forwarding state.
The new MLT-based SMLT appears in the MultiLink/LACP Trunks tab.
The MLT-based SMLT is added.
The SMLT Info tab appears with all the configured MLT-based SMLT displayed.
Comments? infodev@avaya.com
January 2012