Power Lumbar Support ('04 Model) Replacement - Acura 3.5 RL Manual

Power Lumbar Support Replacement
SRS components are located in this area. Review the
SRS component locations and precautions and proce-
dures in the SRS section before performing repair or
service. Refer to the '99 - 01 Acura 3.5 RL Service
Manual, P/N 61SZ305.
CAUTION:
• Put on gloves to protect your hands.
• When prying with a flat-tip screwdriver, wrap it with
protective tape to prevent damage.
NOTE:
• Take care not to bend the cable.
• Take care not to tear the seams or damage the seat
covers.
Remove the back cover (see page 20-4).
2. Release the hook strip on the right inside of the
seat-back.
LUMBAR SUPPORT
MOTOR
HOOK STRIP
SEAT-BACK COVER
3. Disconnect the lumbar support motor connector,
and remove the bolts securing the lumbar support
motor.
7.2 Ibf-ft)
4. Remove the lumbar support, cable, and motor as an
assembly.
- 1 Pull back the edge of the seat-back cover and
pad as needed.
-2 Release the wire tie.
- 3 Release both lower springs.
springs.
LUMBAR SUPPORT
MOTOR
LUMBAR SUPPORT
MOTOR
CONNECTOR