Acura 3.5 RL Manual page 956

Glove box:
1. Remove the dashboard lower cover.
Clip locations, 3
DASHBOARD LOWER
COVER
2. Remove the glove box stop from each side.
Bolt locations, 2
5 x 0.8 mm
9 N-m (0.9 kgf-m,
7 Ibf-ft)
TRUNK LID
OPENER MAIN
SWITCH
CONNECTOR
GLOVE BOX
STOPS
3. Detach the damper clip while holding the glove box,
and disconnect the connector.
4. Remove the bolts, then remove the glove box.
HOOKS
DAMPER
CLIP
DAMPER
CLIP
GLOVE BOX
5. Remove the glove box back cover.
Screw locations, 3
GLOVE BOX
BACK COVER
Detach the
connector.
6. Installation is the reverse of the removal procedure.
Passenger's dashboard panel:
1. Remove the side air vent.
2. Carefully detach the clips, then pull out the passen-
ger's dashboard panel.
Clip locations, 3
CLIPS
3. Installation is the reverse of the removal procedure.
Clip locations, 4
PASSENGER'S
DASHBOARD PANEL