Driver's Window Motor Test ('02-04 Models)
Motor Test:
1.
Remove the driver's door panel.
2.
Disconnect the 6P connector from the window motor.
6P CONNECTOR
3.
Test the motor in each direction by connecting bat-
tery power and ground according to the table.
CAUTION: When the motor stops running, discon-
nect one lead immediately.
4.
If the motor does not run or fails to run smoothly,
replace it.
Terminal side of
male terminals
Pulser Test:
5.
Reconnect the 6P connector to the window motor.
6.
Check for voltage between the terminals.
• There should be battery voltage between the No.
6 (+) and No. 4 (-) terminals when the ignition
switch is ON (II).
• Connect the an analog voltmeter between the
No. 5 (+) and No. 4 (-) terminals, and run the
window motor down or up. The voltmeter needle
should move back and forth alternately.
• Connect the an analog voltmeter between the
No. 3 (+) and No. 4 (-) terminals, and run the
window motor down or up. The voltmeter needle
should move back and forth alternately.
7.
If the voltage does not fluctuate, replace the window
motor.