Installation - Acura 3.5 RL Manual

Installation

CAUTION: Be careful not to bend or damage cylinder
lines A and B or the four fluid lines when installing the
gearbox.
1. Assemble the mounting bracket over the mount
cushion, then loosely install the gearbox on the rear
beam with two gearbox mounting bolts.
NOTE: Move the feed line over the gearbox so that
it does not interfere with the gearbox during instal-
lation.
2. Position the line mounting cushions by aligning the
marks on the 10 mm return line (large diameter
line).
3. Install the feed line on the slot of the cushions.
4. Install the two line clamps on the line mounting
cushions as shown below.
5. Reconnect the feed line to upper side of the valve
body unit.